The module must NOT be used in humid or wet environments.

Specifications:
Input voltage: AC 110...220V
Output voltage: AC 110...220V
Load: 1500W / max 10A
Resolution: 0...99.9 °C: 0.1 °C, other temperature range: 1 °C
Measuring sensor: NTC (10K 0.5%) Waterproof cable 1m
Temperature measurement range: -50...110 °C
Temperature control range: -50...110°C
Temperature display range: 0.0...110 °C
Accuracy of temperature measurement: ±0.2 °C
Temperature control accuracy: ±0.1 °C
[OPTIONAL] Measured temperature correction: -30...30°C
External dimensions: 60 x 45 x 31mm
Sensor probe size: d=4mm, l=20mm
It maintains the set values ​​even in the event of a power failure


Setting the on and off temperature:
1. After switching on, the measured temperature is shown on the display in the default setting.
2. Press the UP button to display the switch-on temperature.
3. Long press the UP button until the display starts flashing, then set the switch-on temperature using the UP and DOWN buttons.
4. Wait until the measured temperature is shown on the display again.
5. Press the DOWN button to display the shutdown temperature.
6. Long press the DOWN button until the display starts flashing, then set the switch-off temperature using the UP and DOWN buttons.
7. Wait until the measured temperature is shown on the display again.

[OPTIONAL] Temperature correction:

1. In the off state, long press the UP and DOWN buttons at the same time while turning on the device. In the factory setting, the value 0.0 appears on the display.
2. Set the measured temperature correction value with the UP or DOWN button. (-30...30°C)
3. Wait until the measured temperature is shown on the display.

Restoring factory settings (RESET):

1. When the measured temperature is displayed, press and hold the UP and DOWN buttons at the same time until 888 is shown on the display.

A modult TILOS párás, nedves környezetben használni!
A modul belsejében a bemeneti fekete és kimeneti fekete vezeték azonos! A relé a bemeneti piros/fázis vezetéket kapcsolja a kimeneti sárga/fázis vezetékre. A fázist tilos a fekete bemenetre kötni, mert így a fázis kikapcsolt állapotban is jelen lesz a kimeneti fekete vezetéken! A modul beszerelését, beüzemelését villamos szakember végezheti.